port forward zyxel

[steven4]

iemand hier ervaring mee?
Snap er niks van:

Ik heb een zyxel p-660H-D3 die schijnt uberhaubt al vrij uniek te zijn.
Maar als ik inlog kom ik niet in het scherm om dingen aan te passen maar in een scherm waar enkel de status van mijn router te vinden is.
Ik doe alles precies hetzelfde als in dit filmpje

http://www.youtube.com/watch?v=128jRWaQWvg
inlog scherm is ook identiek op de naam van de router na. Maar als ik inlog krijg ik dit scherm:

Klik om meer te lezen...

 

[Dennisik]

Router mss even reseten ?

Al wel heb je dan het probleem dat als je niks kan instellen een router hebt die niet werkt of niet beveiligd is

 

[steven4]

router resetten heb ik geprobeerd, haalt niks uit:S

 

[den_dimi]

1 Make sure you are using the correct IP address.
• The default IP address is 192.168.1.1.
• If you changed the IP address (Section 6.3.1 on page 95), use the new IP address.
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for I forgot the IP address for the ZyXEL Device.
2 Check the hardware connections, and make sure the LEDs are behaving as expected. See
the Quick Start Guide.
3 Make sure your Internet browser does not block pop-up windows and has JavaScripts
and Java enabled. See Appendix H on page 333.
4 If you disabled Any IP (Section 6.3.4 on page 97), make sure your computer is in the
same subnet as the ZyXEL Device. (If you know that there are routers between your
computer and the ZyXEL Device, skip this step.)
• If there is a DHCP server on your network, make sure your computer is using a
dynamic IP address. See Section 6.3.1 on page 95. Your ZyXEL Device is a DHCP
server by default.
• If there is no DHCP server on your network, make sure your computer’s IP address is
in the same subnet as the ZyXEL Device. See Section 6.3.1 on page 95.
5 Reset the device to its factory defaults, and try to access the ZyXEL Device with the
default IP address. See Section 2.3 on page 40.
6 If the problem continues, contact the network administrator or vendor, or try one of the advanced suggestions.
Advanced Suggestions
• Try to access the ZyXEL Device using another service, such as Telnet. If you can access
the ZyXEL Device, check the remote management settings and firewall rules to find out
why the ZyXEL Device does not respond to HTTP.
• If your computer is connected to the WAN port or is connected wirelessly, use a computer
that is connected to a LAN/ETHERNET port.

Klik om te verkleinen...

probeer het eens te doen in IE of Chrome ofzo...